Mantis "E" System User Manual download pdf (Page 7)

Tools:

" wrench, pin supplied with the unit or

screwdriver

1. Remove the following parts from the Edge Trimmer

Assembly: blade mounting bolt #1 by rotating it

clockwise, clamping plate #2, gear case cover #3,

holding screws #4, and cover #5. (Pictures 1 and 2)

2. Install the blade guard to the gear case aligning 3

mounting holes (Picture 4), then put on cover #5,

align all holes and install 3 screws. (Picture 5)

3. Attach the blade guard to the tube using Clamping

bracket and two screws. (Picture 6)

4. Install gear case cover (Picture 7), blade (Picture 8),

clamping plate (Picture 9), and install blade

mounting bolt with washers. Left thread, rotate

counter-clockwise to tighten. (Picture 10)

5. Lock the gear shaft by putting a pin provided or

screwdriver through the aligned keyholes in the gear

case cover and the gear case. Use a socket wrench to

tighten the blade-mounting bolt. Rotate bolt counter

clockwise to tighten. (Picture 11)

6. Split the bracket, install the wheel assembly to the

tube, and clamp it at the position best for your job,

using two screws. (Picture 12 and 13)

7. You can replace loop handle with the U-shaped

handle that comes with your Edge Trimmer

Attachment.

Assembling the Edge Trimmer

Picture 1

Picture 2

Picture 3

Picture 4

Picture 5

Picture 6

Picture 7

Picture 8

Picture 9

Picture 11

Picture 10

Picture 12

Picture 13

Gear Case

Blade Guard

Shaft

Clamp

Gear

Case

Cover

Blade

Clamping Plate

Mounting

Bolt

Bracket

Screws

Cover

4.0-4.5”

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Mantis "E" System User Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Mantis "E" System