Mantis "E" System User Manual download pdf (Page 8)

Check the balance of the assembled unit. The handles and

shoulder harness have been assembled at the factory and set

according to the average sized person. This can be adjusted to

the operator’s preference.

1. Unit handles can be re-adjusted to the operator’s

preference by simply loosening the screws and sliding

handles up or down the shaft. Re-tighten the screws

(Picture 16). The distance between the replacement portion

of the blade and the foremost portion of the guiding handle

should be at least 18" (450mm). (Picture 17)

2. Wheel height can be re-adjusted by loosening clamp lever,

and changing the height of the wheel to achieve desired

cutting depth. (Picture 18) Up-deep cut, down-shallow cut.

Balancing and Depth Adjustment

No tools are required to attach the Edge Trimmer to the power

head assembly.

1. Pull the spring pin up on the adapter of the power head

shaft assembly. (Picture 14)

2. Carefully fit edger drive shaft into adapter, making sure

that male spline of the inner drive shaft engages into the

female spline socket of the power head shaft.

3. When the drive shaft is properly aligned, the spring pin

will drop into the hole on the shaft of the edger attachment.

A click should be heard when completed.

4. Insure two shaft parts are fully engaged by twisting them.

5. Full engagement will prevent shaft rotation.

6. Secure assembly by tightening the knob. (Picture 15)

Attaching the Edger to the

Power Head assembly.

Picture 14

Picture 15

Picture 16

Picture 17

Picture 18

down

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Mantis "E" System User Manual Page 8