Mantis 7566 Operator's Manual download pdf (Page 15)

Dealer

1. First, you will need to understand that

your Mantis

Deluxe XP Tiller has an

inner and an outer set of tines on each

side of the tiller as shown in Figure 1.

2. Make sure the tiller is turned off.

3. Remove the retaining pins from the

outer set of tines (Figure 2) and

remove the outer tines.

4. Only after you have removed the outer

set of tines, then remove the retaining

pins from the inner tines and remove

the inner tines from the transmission

axle (Figure 3)

5. Place the right-side set of inner tines

onto the left-side. The “D” shaped

hole should be to the outside. Make

sure the tine retaining pin is installed.

Repeat for the other side

6. Place the right side set of outer tines

onto the left-side axle. The “D” shaped

hole should be to the outside and

insert the tine retaining pin. Repeat for

the other side.

Your Mantis

Deluxe XP Tiller also has

the ability to till or cultivate at either a 9”

or 16” width. The tiller is sent to you set

up for 16”. To run the tiller at a 9” width,

simply remove the inner and outer tines

as noted above. Then just put the outer

tines back onto the transmission axle and

secure with a retaining pin on each side.

Figure 1 Figure 2 Figure 3

Mantis

Deluxe XP Tiller Operation

DO NOT reach your ngers and/or

hand between the tine blades.

DO NOT attempt to remove the

inner set of tines until you have

rst removed the outer set of tines.

IMPORTANT:

To change the tines on your Mantis

Deluxe XP Tiller, push the tiller

forward and allow it to rest on the

loop handle.

To set them for tilling, attach the tines

so the points of the blades face forward

- away from the operator. The tines’

points will contact the ground rst.

For cultivating, reverse the tines

so that the points of the tines face

backward - toward the operator. Now

the long at part of the tine’s blade

will contact the ground rst.

Tilling

Inner Tines

Outer Tines

Cultivating

HOW TO SWITCH FROM TILLING TO CULTIVATING POSITION

Tine

Rotation

Tine

Rotation

Tine Teeth

Back

Handles Handles

Front

401780 Mantis XP Deluxe tiller manual.indd 15 1/24/13 4:07 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Mantis 7566 Operator's Manual Page 15

Comments to this Manuals

Related products and manuals for Mini tillers Mantis 7566