Mantis 7262 Owner's Manual download pdf (Page 7)

7

Assembly (continued)

HOW TO ASSEMBLE

LOWER HANDLES

To identify part numbers, see

pages 6 and 19.

1. Use the protective cardboard

sleeve to stabilize your tiller.

Stand the engine assembly (#21)

up. (Picture 1)

2. Lay the handle parts within easy

reach. You’ll need one of the

handle clamps (#51) and one of

the lower handles (#6). Note that

the lower handles have a short leg

on one end.

3. Fit the handle clamp along the

outside of the short leg. Line up

the holes on the clamp and the leg.

4. Choose one of the two 3-inch

bolts (#49). Slide it through the

first set of holes — near the

elbow where the lower handle

curves. (Pictures 2 & 3)

5. Now slide the other lower handle

onto the 3-inch bolt. Fit the other

clamp onto this other

handle’s short leg. Add a nut

and tighten finger tight.

(Picture 3)

6. Locate the worm gear

housing. It starts just above

— and extends down through

— the tiller’s red fender

guard. You’ll notice that

there’s a recessed channel on

either side of the housing’s top.

(Picture 4.)

7. Take the lower handles that you’ve

just put together. Slide them into

the two recessed channels.

(Picture 5.)

Make sure you insert them from

the rear of the tiller (gasoline tank

faces away

from the operator)... so

that the bolt fits along the back of

the housing.

8. Slide the second 3-inch bolt

through the second set of holes in

the short legs. Add a nut and

tighten finger tight.

Picture 1

Picture 2

Picture 3

Picture 4 Picture 5

NOTE: THE LOCK NUTS ARE STAMPED. FINGER TIGHT IS

APPROXIMATELY 1/2 TO 1-1/2 TURNS.

Contact us at www.mantis.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments