Mantis 7566 Operator's Manual download pdf (Page 10)

Mantis

Deluxe XP Tiller Operator’s Manual

Assembly

• To assemble the upper handles,

rst put the kickstand down.

• Take the right upper handle, the

one with the throttle, and slide it

between the middle handle and the

lower ange of the brace.

• Layout the middle and upper handles

and the handle brace as shown above.

• Insert a curved head bolt into the

slot at the bottom of the upper

handle so that it comes out the

top of the middle handle.

• Take the right middle handle and

attach the brace using a hex head

cap screw and a 2-way lock nut.

Finger tighten.

• Repeat for left side.

• Thread a 2-pronged knob onto

the bolt two full turns while leaving

it loose.

• Repeat for left side.

UPPER HANDLE ASSEMBLY

4 5 6

• Line up the top holes of the upper

handles with the holes on the top of

the brace so the handles are in the

lowest position.

• Insert the round knob into the

brace and tighten.

• Now fully tighten the lower

2-prong knobs.

7 8 9

IMPORTANT NOTE:

Be sure you have proper throttle movements and that the throttle

cable is not wrapped or twisted around the handle bar. Hold down

the lockout lever, fully squeeze the throttle trigger and let go.

Engine throttle triangle must click in both directions. If there is

any doubt, remove air lter and visually check that the throttle

triangle hits both the idle screw and the full open stop. THIS

MUST BE DONE BEFORE STARTING THE ENGINE.

IMPORTANT NOTE:

Make sure you have installed the handles proper-

ly. When you stand behind your tiller, holding the

handles, the fender warning label should face you.

401780 Mantis XP Deluxe tiller manual.indd 10 1/24/13 4:07 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comments to this Manuals

No comments

Mantis 7566 Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Mini tillers Mantis 7566