Mantis 7940 Operator's Manual download pdf (Page 9)

9Contact us at www.mantis.com

Assembly (Continued)

• Attach the Tine so that the circular hole

slides onto the axle rst.

• When the axle protrudes from the

other side it will line up perfectly

with the “D” shaped hole.

4 5

• Position the kickstand brace just above the

bend of the lower handles.

• Position the kickstand under the lower

handles, line up the holes and thread the

kickstand brace bolts into the kickstand.

•Tighten with the 3/8” wrench.

• Your Mantis tiller will look like

this when lower handle assembly

and kickstand is complete.

KICKSTAND ASSEMBLY

1 2 3

IMPORTANT NOTE:

Be sure you have proper throttle movements and that

the throttle cable is not wrapped or twisted around the

handle bar. Hold down the lockout lever, fully squeeze

the throttle trigger and let go. The throttle triangle must

click in both directions. If there is any doubt, remove

air lter and visually check that the throttle triangle hits

both the idle screw and the full open stop. THIS MUST

BE DONE BEFORE STARTING THE ENGINE.

IMPORTANT NOTE:

Before you use your MANTIS Tiller, read the

Safety Rules & Warnings on pages 3-5

IMPORTANT NOTE:

Make sure you have installed the handles properly.

When you stand behind your tiller, holding the handles,

the fender warning label should face you.

Improper Throttle installation can cause tines to rotate unexpectedly.

7940

TINE ASSEMBLY (Continued)

• Slide a retaining pin (T41) through

the hole in the axle to secure the

Tine.

• Repeat steps for the other side.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

No comments

Mantis 7940 Operator's Manual Page 9