Mantis 7262 Owner's Manual download pdf (Page 6)

6

Your MANTIS Tiller comes partially

assembled. You must install only the

handlebars, the carrying handle, and the

tines. This will take just a few minutes if

you follow the directions.

First, take all items out of the carton.

But do not remove the cardboard from

around the Tiller’s base.

The list at the right, shows the parts that

come with your tiller. Check to make sure

you have them.

The bag of hardware is in the plastic bag

containing the Operator/Parts Manual.

To assemble your MANTIS Tiller, you’ll

need two 7/16" wrenches. We suggest that

you install all nuts and bolts only “finger

tight”

— that is, one-half to one full turn

— until you’ve completed assembly. The

nuts are self locking, but you must use

a wrench to tighten them completely.

40

39

8

42

20,21,55

1

2

6

53

Assembly

WARNING•DANGER

IMPROPER ASSEMBLY OF THIS TILLER

CAN RESULT IN SERIOUS INJURY.

MAKE SURE TO FOLLOW ALL

INSTRUCTIONS CAREFULLY.

IF YOU HAVE ANY QUESTIONS

CONTACT OUR FACTORY AT

1-800-366-6268

OR AN AUTHORIZED

MANTIS DEALER

!

!

Quantity Description *Key #

1 Upper Handle Assembly 2

1 Upper Handle Throttle Side Assembly 1

2 Lower Handles 6

1 Pair Tiller/Cultivator Tines 39,40

1 Engine Assembly (includes Fender

Guard & Worm Gear Transmission) 20,21,55

1 Handle Brace 8

1 Plastic Carrying Handle 42

1 Bag of Hardware Containing:

2 Cap Screws 47

4 Lock Nuts 48

2 Bolts (3” long) 49

2 Tine Retaining Pins 41

2 Handle Clamps 51

1 Throttle Clips 13

2 Bolts 52

2 Knobs 53

*These numbers are the same numbers shown on the Parts

Layout on page 19.

Classic 4-Cycle Tiller Operator/Parts Manual

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments